Keep your TX16 safe in style with the official RadioMaster zipper case. This zipper case can be put around the foam box that is always supplied with every TX16s and offers a convenient and safe way to transport your favorite transmitter.
This Radiomaster AG01 Full CNC Hall Gimbal Set was designed and tested for over a year. This set features both the Self-Centering Gimbal and the Throttle Gimbal.
AD1 10A/100W Multi Function Intelligent Touch DUO Balance Charger/Discharger A series is a upgrade series which is designed for professional users with more...
Introducing the Radiomaster R-Series! This R81 Nano Receiver (with Sbus Output) has 8 channels and is Frsky D8 compatible, offering a range suitable for both drone and RC modelers.
Introducing the Radiomaster R-Series! This R161 Sbus Receiver (with S.Port Output) has 16 channels and is Frsky D16 compatible, offering a range suitable for both drone and RC modelers.
Introducing the Radiomaster R-Series! This R168 PWM Receiver (with Sbus Output) has 16 channels and is Frsky D16 compatible, offering a range suitable for both drone and RC modelers.
On-board Ultra low noise 3.3V voltage regulator and RF filter for noise blocking
Features an additional front-end LNA for optimized performance and a front-end SAW filter for increased jamming immunity
Build-in embedded GNSS patch antenna, low power consumption
The 15 x 15 mm patch antenna provides the best compromise between the performance of a Right Hand Circular Polarized (RHCP) antenna and a small size to be integrated in any design.
Magnetic sensor QMC5883L integrated
Max navigation update rate
Single GNSS up to 18 Hz
2 Concurrent GNSS(GPS & GLONASS) up to 10 Hz
Horizontal position accuracy(GPS & GLONASS) 2.5 m CEP
Velocity accuracy 0.05m/s
Cold start 26 s
Aided cold starts: 2 s
Hot start 1 s
Frame Diagram Link Roma F5 DJI Intro Roma F5 DJI Frame: Wheelbase :226mm Weight :135g Prop Siza :5 inch FC Mounting: 30.5×30.5(M3)&20×20mm(M2) Motor Mounting:16mm Top...
The best drone backpack for DJI Mavic series and foldable drones. Specially designed for the DJI Mavic series backpack turns easily from a daypack into...
TAYCAN 25 Frame Kit Specification Frame Diagram Link Wheelbase :125mm Weight :86g Prop Siza :2.5 inch FC Mounting:20×20&25.5×25.5m(M2) Motor Mounting:9mm&12mm Top Plate 1.5mm Bottom Plate...
The OmniNXT F7 is Airbot’s top of the range flight controller based on the newly designed NXT architecture. It uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard damping box, the gyros run perfectly under 32k looptime. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. The NXT also comes with 2 different BECs and 6 UARTs.
FIRMWARE TARGET : MAMBA F722 (LEGACY) Diagram Link From Help Centre Link Note:Because STM32F722 heat large , please leave at least 5mm interspace at both sides of...
The Omnibus Fireworks flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box, the ICM20608 runs perfectly under 32k Gyro loop. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. Also onboard are a barometer and AB7456 OSD chip for the BetaFlight integrated OSD.