No products in the cart.
Return To Shop
Telemetry Radio V3 433MHz
A Holybro Telemetry Radio is a small, light and inexpensive open source radio platform that typically allows ranges of better than 300m “out of the box”). The radio uses open source firmware which has been specially designed to work well with MAVLink packets and to be integrated with the Mission Planner, Copter, Rover and Plane.
SPECIFICATIONS
Processing:
● 10 mW maximum output power (adjustable) -117 dBm receive sensitivity
● Open-source SIK firmware
● RP-SMA connector
● 2-way full-duplex communication through adaptive TDM UART interface
● Transparent serial link
● MAVLink protocol framing
● Frequency Hopping Spread Spectrum (FHSS) Configurable duty cycle
● Error correction corrects up to 25% of bit errors Open-source SIK firmware
● Configurable through Mission Planner & APM Planner
● FT230X is a USB to BASIC UART IC
Features
Interchangeable air and ground modules 433 mHz
Micro-USB port
6-position JST-GH connector
•Dimensions
28 x 53 x 10.7mm (without antenna)
28 x 53 x 10.7mm (without antenna)
•Power
Supply voltage: 5VDC (from USB or JST-GH)
Transmit current: 100 mA at 20dBm
Receive current: 25 mA
Serial interface: 3.3 V UART
Supply voltage: 5VDC (from USB or JST-GH)
Transmit current: 100 mA at 20dBm
Receive current: 25 mA
Serial interface: 3.3 V UART
•Status LEDs
The radios have 2 status LEDs, one red and one green. The meaning of the different LED states is:
Green LED blinking – searching for another radio
Green LED solid – link is established with another radio
Red LED flashing – transmitting data
Red LED solid – in firmware update mode
• Connecting to Pixhawk4
Use the 6 pin JST-GH connector that should have come with the radio to connect the radio to your Pixhawk4’s “Telem 1” (“Telem 2” can also be used but the default recommendation is “Telem1”).
The radios have 2 status LEDs, one red and one green. The meaning of the different LED states is:
Green LED blinking – searching for another radio
Green LED solid – link is established with another radio
Red LED flashing – transmitting data
Red LED solid – in firmware update mode
• Connecting to Pixhawk4
Use the 6 pin JST-GH connector that should have come with the radio to connect the radio to your Pixhawk4’s “Telem 1” (“Telem 2” can also be used but the default recommendation is “Telem1”).
• Connecting to a PC
Connecting the radio to your Windows PC is as simple as connecting the micro USB cable (which should have been included with the radio) to your PC. The necessary drivers should be installed automatically and the radio will appear as a new “USB Serial Port” in the Windows Device Manager under Ports (COM & LPT). The Mission Planner’s COM Port selection drop-down should also contain the same new COM port.
Package Included:
2x radio modules with antennas
1x Micro-USB cable
1x Android OTG adapter cable *1
1x GH 6P-GH 6P cable *1
1x MLX 6P-GH 6P cable *1
1x Type C to Micro USB Adapter Converter
Download
Only logged in customers who have purchased this product may leave a review.
Related products
Telemetry Radio V3 433MHz €67.19
Reviews
There are no reviews yet.