With the growing acclaim of the new compact X-Lite form factor, FrSky is introducing this upgraded version. The Pro and S versions combine all the benefits of the preceding design with the features of our full-sized radios, along with the newly developed ACCESS.
Mini Carrier Board has the standardized DF17 connector which allows user to connect it to every version of the Cube flight controller. With smaller size...
Advanced Continuous Channel Shifting Technology (ACCST SYSTEM) achieves highly reliable link in interference rich environments. Smart Port – Full Duplex communication Easy to bind and...
The F60 Pro III continues the lineage of great FPV racing motors by T-Motor. The Pro III provides more thrust and increased durability compared to its predecessor.
The F60 Pro IV continues the lineage of great FPV racing motors by T-Motor. The Pro IV provides more thrust and increased durability compared to its predecessor.Equipped with high-temperature silver-core windings able to withstand up to 97C, after 100% throttle running 1 min. The overall stability of the motor has been enhanced. The threading has also been strengthened to prevent stripping or fracturing of the motor shaft. Each Pro IV motor is supplied with high-quality EZO bearings for maximum performance and lifespan. The new bell design looks amazing, while also providing the same non-slip propeller grip like the Pro III.
Holybro Kakute F7 HDV is designed to work with the DJI FPV VTx module. The GH port available on the board makes it much more convenient for you to connect Holybro Kakute F7 HDV to the DJI FPV VTx, for both signal and power supply.
This mini camera provides some incredible specs for 1200TVL resolution and WDR worldwide. EOS2 is equipped with 1/3 CMOS sensor and 2.1mm lens with a 16:9 projection ratio.This camera is well suited to micro-structures that requires maximum weight and space Reduction without compromising quality.
FIRMWARE TARGET : MAMBA F722 (LEGACY) Diagram Link From Help Centre Link Note:Because STM32F722 heat large , please leave at least 5mm interspace at both sides of...
The FrSky Taranis X9D Plus Special Edition (SE) 2019 is a re-designed version with additions, like a momentary button and a program scroll wheel, making it even easier for DLG pilots to navigate the menus! The SE comes with upgraded switches, gimbals, and wireless PARA functionality.
I want freestyle frame to show more performance in flight,a Super lightweight Freestyle frame,more convenient installation of electronic devices and more balanced center of gravity, so as to achieve better Smooth flight shooting, These ideas build the freestyle frame Mark4.
Get Started on your road to Autonomy! This Kit contains the following items The Cube…. the brains behind the opperation. A standard carrier board.(no compatible...
INSIDE THE CUBE An STM32F427 Rev 3 Flight management unit. (where the flight controller lives.) An STM32F100 I/O processor with pass through capabilities for...
Cube Yellow target to education, drones lovers and professional cost-effective flight control hardware providers. The new generation of more powerful F7 processor, stronger performance, faster,...
The NEO-M8 is optimized for cost sensitive applications, while NEO-M8N and NEO-M8Q provide best performance and easier RF integration. The NEO form factor allows easy migration from previous NEO generations. Sophisticated RF-architecture and interference suppression ensure maximum performance even in GNSS-hostile environments.
What’s inside Here+ RTK Base & HERE 3 (M8P) Combo (Separated products) Highlights Centimeter‑level GNSS positioning for the mass market Integrated Real Time Kinematics (RTK)...
Here is another super affordable package added to our 1S batteries to make those indoor race session even more fun.Fits Emax Tinyhawk, Mobula 7 and similar frames.Package includes:5 x Infinity 1S 450mAh 85C HIGH VOLTAGE Specifications:3.8V-4.35V 450mAh 1S 85C/170C Lipo BatteryCapacity:...
• Working noiselessly with excellent stability, fast response and high efficiency
• Easy to handle for both newbies and veterans
• Suitable for various frames for diverse demands
The T-Motor F55A 4-in-1 ESC is fully capable of pushing 6s with 75A burst and a sustained 55A current draw. Equipped with the latest in ESC technology such as 32-bit capability and BLHeli32 firmware.
T-Motor updated their F45 ESC with BLHeli_32 firmware. This tiny ESC packs 45A into an industrialized PCB layout made with premium features such as a 32bit main control chip, programmable LEDs, and BLHeli_32 firmware.
This ESC is T-Motor's 4-in-1 version of their popular F45A ESC. This 4-in-1 ESC packs 45A into an industrialized PCB layout made with premium features such as a 32bit main control chip, BLHeli_32 firmware, and 6s support.
Pixhawk ® 4 is the latest update to the successful family of Pixhawk flight controllers. It is designed and developed in collaboration with Holybro and...
The S8R is a FrSky 8 and 16 channels receiver built-in 3-axis gyroscope and 3-axis accelerometer sensor module. For conventional Fixed Wing and Glider Models it will support stabilization, automatic level, hover and Knife-edge flight modes, for Delta Wings or flying wings and V-tail models it supports stabilization and automatic level flight modes. You can edit the type of model and manipulate all these features via the S8R.Config or S8R.lua. The S8R can also be used as a standard 8 channel X series receiver if it is required.
The FrSky Wireless USB Dongle For Simulator allows you to wirelessly connect your FrSky transmitter to computer to use simulator. Just install the pre-loaded HID driver to your PC (Mac users will need to download the correct HID drivers). Then bind your transmitter to it, now you can move freely while using a simulator.
FrSky Compact XSR-SIM USB Dongle supports most simulators which have no hardware encrypted.
An upgraded version based on the RX8R receiver, it has all the same features including redundancy. The Pro version has higher precision and lower latency. Its deviation of PWM is reduced to 0.5us, and the delay of PWM output is 9ms less than that of the X8R in high-speed mode. A feature that deserves mention is the decreased effect of interference caused by the ignition process.
POPO compatible propellers from Tiger Motors. These ultralight and thin bladed props are made for high kv motors and high speeds where they are most efficient.
Get ahead of the curve with the next game changing transmitter from FrSky, the Taranis X-Lite. This revolutionary radio blends the functionality and reliability of FrSky Transmitters with a compact Game-Style controller.
Description After the huge success of the 1550 100C, Infinity introduces their next power house 1550mAh 120C continuous and 240C Burst pack. Description: Brand name:...
This is a frame designed for Freestyle, called “Mark2”. After repeated design adjustment and testing, finally finished, let us present to you.
Although Mark2 is a regular rectangular frame, it still wants you to know its design features. A lot of mechanical shapes are added to the design, and the whole is very sexy and science fiction. The four arm and aluminum alloy parts are fixed, easy to replace the new machine arm, and the fixed performance is good. The camera position can be very good to protect the camera from damage
High-precision CNC aluminum alloy fixed parts, 3K full carbon fiber, 12.9 level YFS screw, give Mark2 to maintain strength advantage.
Enjoy Freestyle.
• Ultralight design with only 29.5g. Champion's choice for racing• High efficiency KV1600 runs well with 5”,6”,7”@4S-6S for long range flight• KV2400,KV2600 with high torque is extremely explosive & Efficient• Max Thrust: 1.62kg
GEP-GR2306 is the enamored production of our GEPRC. It passes our performance test in all aspects, and it can meet our extreme requirement on the parameter of the appearance of the electrical machine totally. Its elaborate appearance processing makes our eyes light up and we believe that the strong and steady power take-off will meet your expectation.
Our team keeps thinking that how to make a rack which is balanced both in competition and freestyle. Perhaps, GEP-KX5 can make you feel the good balance by its new and fresh design.GEP-KX5 is wished to be designed as a rack which is quite elegant and graceful. This is the reason why it is named as “Elegant”.
FrSky M9-R Gimbal is specially designed for FPV racing, 3D and acrobatic fixed wing and 3D Heli pilots who are using the
FrSky Taranis X9D/X9D Plus Transmitter. The Wider 45°throttle travel will allow you to achieve an extreme amount of throttle
resolution resulting in precision control,. The combination of a hall sensor gimbal and included lotus stick ends will assure that
your thumbs or fingers are with one with the radio. We gave it a red metal body to give it that race ready look.
Upgrade your Taranis Q X7 with this plug-n-play high resolution M7 Gimbal from FrSky. The highly sensitive Hall sensors will not wear out quickly. It has an extremely smooth feel with the quad ball-bearings and the metal outer construction. Thicker 4mm stick ends give you a solid link to your controls. Fully adjustable tension and easily disable the self centering axis with one screw. This is a must have accessory for achieving those precision flight maneuvers.
FrSky ultra mini receiver R-XSR is the evolution of FrSky full range XSR receiver. The R-XSR is a standalone receiver with all the functions of XSR, in addition, it’s almost 1/3 size and 1/3 weight of XSR receiver. Moreover, there redundancy function is integrated into this tiny receiver ensures the security, and the IPEX connector makes it more convenient for you to replace antennas.