Material Toray T700 green carbon with silky coating Wheelbase 210mm Mouting hole 20×20/25.5×25.5 M2 Camera size 19x19mm Micro Size System Analog Cam/ HD Vista digital...
The Vista was fully authorized by DJI and compatible with their HD FPV System. Even better, the Caddx Vista was engineered to be lighter and smaller than the DJI Air Unit Module and also comes with mounting holes for easier installation onto your quad!
A single-camera module, which has a quick-release design for convenient replacement. The FPV camera does not come with a back cover or coaxial cables installed.Does not come with Air Unit Module. Cable not included, this is the camera only.
The Caddx Polar Micro Camera is an FPV camera with a mega starlight sensor. The Caddx Polar has a minimum 720p 60fps image transmission, with a transmission range of up to 4km and a minimum end-to-end latency within 32 ms. The camera is compatible with Vista and Air Unit modules.
Enhance your UAV fleet with Precision Landing and target recognition features. Attach the IR-LOCK Sensor to your UAV, and place the MarkOne Beacon where you want to land. Great...
The CADDX VISTA KIT Micro Version is a replacement for the DJI Air Unit. With a micro-sized 19x19 camera, the Caddx Air Unit has all the features and performance of the original.The CADDX VISTA KIT features an ultra-low-latency high-definition digital image transmission, 1080p/60fps video recording, and eight frequency channels, allowing eight pilots to fly simultaneously.Compatible with DJI's Digital FPV Goggles, CADDX VISTA KIT (Digital VTX + HD FPV Camera) provides amazingly clear video, low latency, and even a built-in 1080P/60 FPS DVR.
The Caddx Nebula Nano V2 Digital FPV Camera Kit is an advanced video transmission module that supports a 5.8GHz digital video signal and 720p 60fps image transmission.
A replacement or spare antenna for the Caddx Vista Specifications Brand: Caddx FPV Variant: Standard 8cm / 15Cm Weight: 4 g Includes 1 x Caddx Vista...
Radiolink Pixhawk is a real king of the open source flight controller made by Radiolink. On the basis of 3DR PIX function, it developes optimized circuit design and creative design automation software QA system, which guarantee the quality of product.
On-board Ultra low noise 3.3V voltage regulator and RF filter for noise blocking
Features an additional front-end LNA for optimized performance and a front-end SAW filter for increased jamming immunity
Build-in embedded GNSS patch antenna, low power consumption
The 15 x 15 mm patch antenna provides the best compromise between the performance of a Right Hand Circular Polarized (RHCP) antenna and a small size to be integrated in any design.
Magnetic sensor QMC5883L integrated
Max navigation update rate
Single GNSS up to 18 Hz
2 Concurrent GNSS(GPS & GLONASS) up to 10 Hz
Horizontal position accuracy(GPS & GLONASS) 2.5 m CEP
Velocity accuracy 0.05m/s
Cold start 26 s
Aided cold starts: 2 s
Hot start 1 s
Frame Diagram Link Roma F5 DJI Intro Roma F5 DJI Frame: Wheelbase :226mm Weight :135g Prop Siza :5 inch FC Mounting: 30.5×30.5(M3)&20×20mm(M2) Motor Mounting:16mm Top...
TAYCAN 25 Frame Kit Specification Frame Diagram Link Wheelbase :125mm Weight :86g Prop Siza :2.5 inch FC Mounting:20×20&25.5×25.5m(M2) Motor Mounting:9mm&12mm Top Plate 1.5mm Bottom Plate...
Herelink AccessoriesHerelink is an all-in-one solution for long-range HD video transmission, which can realize video, data transmission and radio control. The 2.4GHz radio controller with built-in screen...
Mini Carrier Board has the standardized DF17 connector which allows user to connect it to every version of the Cube flight controller. With smaller size...
This mini camera provides some incredible specs for 1200TVL resolution and WDR worldwide. EOS2 is equipped with 1/3 CMOS sensor and 2.1mm lens with a 16:9 projection ratio.This camera is well suited to micro-structures that requires maximum weight and space Reduction without compromising quality.
The OmniNXT F7 is Airbot’s top of the range flight controller based on the newly designed NXT architecture. It uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard damping box, the gyros run perfectly under 32k looptime. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. The NXT also comes with 2 different BECs and 6 UARTs.
FIRMWARE TARGET : MAMBA F722 (LEGACY) Diagram Link From Help Centre Link Note:Because STM32F722 heat large , please leave at least 5mm interspace at both sides of...
Get Started on your road to Autonomy! This Kit contains the following items The Cube…. the brains behind the opperation. A standard carrier board.(no compatible...
INSIDE THE CUBE An STM32F427 Rev 3 Flight management unit. (where the flight controller lives.) An STM32F100 I/O processor with pass through capabilities for...
Cube Yellow target to education, drones lovers and professional cost-effective flight control hardware providers. The new generation of more powerful F7 processor, stronger performance, faster,...
What’s inside Here+ RTK Base & HERE 3 (M8P) Combo (Separated products) Highlights Centimeter‑level GNSS positioning for the mass market Integrated Real Time Kinematics (RTK)...
The Omnibus Fireworks flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box, the ICM20608 runs perfectly under 32k Gyro loop. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. Also onboard are a barometer and AB7456 OSD chip for the BetaFlight integrated OSD.
The Foxeer line of antennas provides many different options for all FPV enthusiasts needs. If you're looking for a specific color, length, Left Hand Polarization, or Right Hand Polarization. These antennas can be used both on the Video Transmitter side, and the Video Receiver side.
Main Features:
- 1200TVL HD image, 1280 ( H ) x 960 ( V ), 16:9 aspect ratio
- Built-in OSD and microphone for flight data display and more immersion respectively
- Compatible with various devices - PAL / NTSC switchable, 5 - 40V input voltage range